Each pair is routed over in-service submarine cables and straight overland links, separately on each model.
A round-trip time below the fibre propagation floor along a model's route is inconsistent with that model.
Results by model
Propagation limits
Light travels at 299,792 km/s in vacuum and at 204,190 km/s in standard single-mode fibre (group index 1.468). Submarine cables are fibre, so the minimum round-trip time over a route is 2 × route length ÷ 204,190 km/s. This floor determines each bar and the speed of the animated markers on the map.
Measured times exceed the floor because installed cable is longer than its charted route and because routers and queues add delay. A time above the floor is therefore uninformative. A time below it implies that the model places the endpoints too far apart.
The vacuum speed exceeds the fibre speed by 47%, and radio propagation through air is within 0.03% of the vacuum speed. A time below the vacuum floor cannot be achieved by cable, radio or satellite.
Implied propagation speed
Distance on each model
All measurements
Cable crossings
RIPE Atlas anchor-to-anchor traceroutes. The increase in round-trip time at the hop that spans the sea isolates the cable segment; it is compared with the fibre floor along that cable's charted route.
Bars: round-trip fibre floor along the cable's charted route. White mark: measured increase, minimum over 24 hours of traceroutes at 15-minute intervals. Select a crossing to show its route on the map.
Networks on the measured paths
Every endpoint and traceroute hop was attributed to the autonomous system (AS) that announced its address in the public BGP routing table on 23 October 2026 (RouteViews route-views2, via CAIDA prefix2as), named from the regional internet registries' AS list (RIPE NCC). Addresses absent from the table were matched to internet exchange point prefixes registered in PeeringDB. Each hop is a router of an identified network, and adjacent networks exchange traffic only under peering or transit agreements configured by both parties. The attribution can be repeated from the cited public sources.
Measurement endpoints
RIPE Atlas anchors
Carriers on the Vultr traceroutes
Internet exchange points
Sea crossings: networks either side of the jump
Independent verification
To reproduce a measurement, ping one of the anchors from any computer and enter the minimum round-trip time. Local network and access delays can only increase the measured value.
Code and data
The code, the raw measurement logs and the derived data are public. Code is released under the MIT licence; the measurements and derived data under CC BY 4.0. Third-party inputs remain under their own terms and are downloaded by a script rather than redistributed.